Because of their own structure, they can show the user the same shear stress and anti support force from beginning to end. There is a kind of structural rivet, which can lock the journal position to the bolt body when riveting, which makes the bolt and journal share a common cutting surface, showing the user's high shear value, and the tensile strength is also improved. The high clamping load caused by the high support force of the bolt journal makes the journal lock to the actual locking effect of the bolt itself. Structural studs can be used to replace single-sided solid core bolts. When installing, they are only applied to one side of the product workpiece. However, the single-sided solid core bolts must be applied to both sides of the product workpiece before installation. In terms of installation cost, structural studs also save a lot of money than single-sided solid core bolts.

Bolt is a part which can make full use of deformation or interference to connect riveted parts in riveting. There are many types of bolts, aluminum iron rivets and flexible. There are many types of bolts, such as BS countersunk head bolt, BS pipe bolt, BS flat head bolt, BS half round head bolt, BS headless bolt, BS large flat round head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS flat head bolt, BS S cylinder head half empty center bolt, BS yellow bolt, BS back spoon flat bolt, BS round mouth bolt, BS core bolt, BS cone head bolt, BS core rivet, BS core bolt, BS half center bolt, BS logo bolt, BS half countersunk head bolt, BS pipe bolt, BS flat cone head bolt, BS small flat head bolt, BS semicircular head bolt, BS round head bolt, BS round head bolt and BS large flat circle bolt However, the specifications and models should be specified in detail as follows: the diameter of the top of the head of the double drum rivet manufacturer * the thickness of the top part of the head * the length of the pipe diameter (excluding the thickness of the head) × diameter * the depth of the hole. In general, the specifications for the diameter and the deep layer are available If you don't have engineering drawings or photos, you should include this factor. If you tell the raw materials, most of them can be manufactured immediately.